M25P10-AVMP3TSLASHX datasheet(18/49 Pages) STMICROELECTRONICS

18 / 49 page

Instructions

M25P10-A

18/49

6.3

Read Identification (RDID)

The Read Identification (RDID) instruction is available in products with Process Technology

code X only.

The Read Identification (RDID) instruction allows the 8-bit manufacturer identification to be

read, followed by two bytes of device identification. The manufacturer identification is

assigned by JEDEC, and has the value 20h for STMicroelectronics. The device identification

is assigned by the device manufacturer, and indicates the memory type in the first byte

(20h), and the memory capacity of the device in the second byte (11h).

Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is

not decoded, and has no effect on the cycle that is in progress.

The Read Identification (RDID) instruction should not be issued while the device is in Deep

Power-down mode.

The device is first selected by driving Chip Select (S) Low. Then, the 8-bit instruction code

for the instruction is shifted in. This is followed by the 24-bit device identification, stored in

the memory, being shifted out on Serial Data Output (Q), each bit being shifted out during

the falling edge of Serial Clock (C).

The instruction sequence is shown in Figure 9

The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at

any time during data output.

When Chip Select (S) is driven High, the device is put in the Stand-by Power mode. Once in

the Stand-by Power mode, the device waits to be selected, so that it can receive, decode

and execute instructions.

Figure 9.

Read Identification (RDID) Instruction Sequence and Data-Out Sequence

Table 5.

Read Identification (RDID) Data-Out Sequence

Manufacturer Identification

Device Identification

Memory Type

Memory Capacity

20h

11h

3456789 10 11 12 13 14 15

Instruction

AI06809b

Manufacturer Identification

High Impedance

MSB

15 14 13

3210

Device Identification

MSB

16 17 18

28 29 30 31

M25P10-AVMP3T/X Datasheet(PDF) 18 Page - STMicroelectronics

M25P10-AVMP3T/X Datasheet(HTML) 18 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Descarga

Enlace URL