M45PE16 datasheet(21/45 Pages) STMICROELECTRONICS

No. de pieza	M45PE16

Descripción Electrónicos	16 Mbit, low-voltage, Page-Erasable Serial Flash memory with byte alterability and a 50 MHz SPI bus interface

PDF	45 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

21 / 45 page

M45PE16

Instructions

21/45

6.4

Read Status Register (RDSR)

The Read Status Register (RDSR) instruction allows the Status Register to be read. The

Status Register may be read at any time, even while a Program, Erase or Write cycle is in

progress. When one of these cycles is in progress, it is recommended to check the Write In

Progress (WIP) bit before sending a new instruction to the device. It is also possible to read

the Status Register continuously, as shown in Figure 9.

The status bits of the Status Register are as follows:

6.4.1

WIP bit

The Write In Progress (WIP) bit indicates whether the memory is busy with a Write, Program

or Erase cycle. When set to 1, such a cycle is in progress, when reset to 0 no such cycle is

in progress.

6.4.2

WEL bit

The Write Enable Latch (WEL) bit indicates the status of the internal Write Enable Latch.

When set to 1 the internal Write Enable Latch is set, when set to 0 the internal Write Enable

Latch is reset and no Write, Program or Erase instruction is accepted.

Figure 9.

Read Status Register (RDSR) instruction sequence and data-out

sequence

Table 5.

Status Register Format

WEL(1)

WEL and WIP are volatile read-only bits (WEL is set and reset by specific instructions; WIP is automatically

set and reset by the internal logic of the device).

WIP(1)

3456789 10 11 12 13 14 15

Instruction

AI02031E

6543210

Status Register Out

High Impedance

MSB

6543210

Status Register Out

MSB

M45PE16 Datasheet(PDF) 21 Page - STMicroelectronics