AD5100EVAL datasheet(18/32 Pages) AD

No. de pieza	AD5100EVAL

Descripción Electrónicos	System-Management IC with Programmable Quad Voltage Monitoring and Supervisory Functions

PDF	32 Pages

Scroll/Zoom	100%

Fabricante Electrónico	AD [Analog Devices]

Página de inicio	http://www.analog.com

Logo

18 / 32 page

AD5100

Preliminary Technical Data

Rev. PrJ | Page 18 of 32

Fault Detection with Shutdown Warning

An early shutdown warning is available for the system

processor to identify the source of failure and take

appropriate action before shuting down the external devices.

Whenever the voltage at V1MON is detected as over-voltage or

under-voltage, or the voltage at V2MON falls below the

threshold, SHDNWARN outputs a logic 0. If the processor sees

a logic-low on this pin, the processor may issue an I2C read

command to identify the cause of failure reported in the Fault

Detect/Status Register. The processor may store the

information in the external EEPROM as a record of failure

history.

V4OUT

V4OUT is an open-drain output triggered by V4MON wth

minimum propogation delay and the programmable delay

does not apply. V4OUT can be used as a PWM control over an

external device or used as a monitoring signal. Most

applications using V4OUT require disabling V4MON triggered

reset with an I2C command.

AD5100EVAL Datasheet(PDF) 18 Page - Analog Devices