ADF4193BCPZ datasheet(7/28 Pages) AD

7 / 28 page

ADF4193

Rev. B | Page 7 of 28

Pin No.

Mnemonic

Description

RSET

Connecting a resistor between this pin and GND sets the charge pump output current. The nominal voltage bias at

the RSET pin is 0.55 V. The relationship between ICP and RSET is

ICP = 0.25/RSET

So, with RSET = 2.4 kΩ, ICP = 104 μA.

VP2

Power Supply Pin for the Charge Pump. Nominally 5 V, should be at the same voltage at VP1. A 0.1 μF decoupling

capacitor to ground should be placed as close as possible to this pin.

AIN−

Differential Amplifier’s Negative Input Pin.

CPOUT−

Differential Charge Pump’s Negative Output Pin. Should be connected to AIN− and the loop filter.

SW2

Fast Lock Switch 2. This switch is closed to SWGND while the SW1/2 timeout counter is active.

SWGND

Common for SW1 and SW2 Switches. Should be connected to the ground plane.

SW1

Fast Lock Switch 1. This switch is closed to SWGND while the SW1/2 timeout counter is active.

CPOUT+

Differential Charge Pump’s Positive Output Pin. Should be connected to AIN+ and the loop filter.

AIN+

Differential Amplifier’s Positive Input Pin.

VP3

Power Supply Pin for the Differential Amplifier. This can range from 5.0 V to 5.5 V. A 0.1 μF decoupling capacitor to

ground should be placed as close as possible to this pin. Also requires a 10 μF decoupling capacitor to ground.

ADF4193BCPZ Datasheet(PDF) 7 Page - Analog Devices