AM29LV641MH datasheet(13/60 Pages) SPANSION

13 / 60 page

December 21, 2005

Am29LV641MH/L

DA TA SH EET

dresses are changed. While in sleep mode, output

data is latched and always available to the system.

Refer to the DC Characteristics table for the automatic

sleep mode current specification.

RESET#: Hardware Reset Pin

The RESET# pin provides a hardware method of re-

setting the device to reading array data. When the RE-

SET# pin is driven low for at least a period of tRP, the

device immediately ter minates any operation in

progress, tristates all output pins, and ignores all

read/write commands for the duration of the RESET#

pulse. The device also resets the internal state ma-

chine to reading array data. The operation that was in-

terrupted should be reinitiated once the device is

ready to accept another command sequence, to en-

sure data integrity.

Current is reduced for the duration of the RESET#

pulse. When RESET# is held at V

SS±0.3 V, the device

draws CMOS standby current (I

CC4). If RESET# is held

at V

IL but not within VSS±0.3 V, the standby current will

be greater.

The RESET# pin may be tied to the system reset cir-

cuitry. A system reset would thus also reset the Flash

memory, enabling the system to read the boot-up firm-

ware from the Flash memory.

Refer to the AC Characteristics tables for RESET# pa-

rameters and to Figure 17 for the timing diagram.

Output Disable Mode

When the OE# input is at V

IH, output from the device is

disabled. The output pins are placed in the high

impedance state.

AM29LV641MH Datasheet(PDF) 13 Page - SPANSION