HC705E5GRSSLASHD datasheet(67/148 Pages) NXP

67 / 148 page

MC68HC705E5 — Rev. 1.0

General Release Specification

Computer Operating Properly (COP) Watchdog

General Release Specification — MC68HC705E5

Section 10. Computer Operating Properly (COP)

Watchdog

10.1 Contents

10.2

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .67

10.3

System Control and Status Register. . . . . . . . . . . . . . . . . . . . .68

10.4

COP During Wait Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .70

10.5

COP During Stop Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .70

10.2 Introduction

The COP watchdog system is a mask-programmable feature which will

generate a system reset if not serviced within the specified COP timeout

period. The COP counter chain is derived from an output of the CPI

circuit. This input signal is divided to give the COP reset rate selected by

the first write to the system control and status register (SCSR) located at

address $13.

A COP reset is done by writing a logic 0 to bit zero of address $1FF0.

This will reset the COP counter chain and begin the timeout countdown

again. The COP counter chain is also cleared when the MCU is in reset

or stop mode.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705E5GRS/D Datasheet(PDF) 67 Page - NXP Semiconductors