24LLC02

2K-Bits Serial EEPROM For Low Power

* All specs and applications shown above subject to change without prior notice.

1F-5 NO.66 SEC.2 NAN-KAN RD ., LUCHU ,

TAOYUAN, TAIWAN

Email: server@ceramate.com.tw

Tel:886-3-3214525

Http: www.ceramate.com.tw

Fax:886-3-3521052

Page 12 of 19

Rev 1.0 Dec. 26, 2001

RANDOM ADDRESS BYTE READ OPERATION

Using random read operations, the master can access any memory location at any time. Before it issues the

is performed in the following steps:

1. The master first issues a Start condition, the slave address, and the word address to be read. (This step sets

the internal word address pointer of the 24LLC02 to the desired address.)

2. When the master receives an ACK for the word address, it immediately re-issues a start condition followed

3. The 24LLC02 then sends an ACK and the 8-bit data stored at the desired address.

4. At this point, the master does not acknowledge the transmission, but generates a stop condition instead.

5. In response, the 24LLC02 stops transmitting data and reverts to its stand-by mode (see Figure 1-13).

Slave Address

Word Address

Start

A

C

K

A

C

K

Slave Address

A

C

K

N

O

A

C

K

Stop

Start

Data (n)

Figure 1-13. Random Address Byte Read Operation