MC44BS373CAD datasheet(2/52 Pages) MOTOROLA

2 / 52 page

MC44BS373CA Data Sheet

MOTOROLA

Features

1 Features

The MC44BS373CA is a multi-standard, PAL/SECAM/NTSC modulator.

The channel is set by an on-chip high-speed I2C-compatible bus receiver. A phase-locked loop (PLL) tunes

the modulator over the full UHF range.

The modulator incorporates a sound subcarrier oscillator and uses a second PLL to derive 4.5-, 5.5-, 6.0-,

and 6.5-MHz subcarrier frequencies. These frequencies are selectable by bus.

The modulation standard can be chosen using a control bit that selects between positive and negative

modulation.

The picture-to-sound ratio may be adjusted using the bus. In addition, an on-chip video test pattern generator

can be switched on with a 1-kHz audio test signal.

The MC44BS373CA also has the following features:

•

Integrated on-chip programmable UHF oscillator

•

No external varicaps diodes/inductor or tuned components

•

Extremely low external component count

•

Channel 21–69 UHF operation

•

VHF range possible by internal dividers (30–450 MHz)

•

Boosted TVOUT level (82 dB

µV typical)

•

High-speed read and write I2C bus compatible (800 kHz)

•I2C address selectable by pin (four choices) using external resistor (available only in QFN20

package)

•I2C bus 5- and 3.3-V compatible

•

Fixed video modulation depth (93% typical in system L and 82% typical in the other standards)

•

Peak white clip disabled by bus

•

Programmable picture/sound carrier ratio (12 and 16 dB)

•

Integrated on-chip programmable sound subcarrier oscillator (4.5, 5.5, 6.0 and 6.5 MHz)—no

external varicaps

•

Programmable sound reference frequency (31.25 and 62.5 kHz)

•

Direct RF sound modulator input (FM and AM modulator bypassed) for NICAM or stereo sound

applications (available only in QFN20 package)

•

On-chip video test pattern generator with sound test signal (1 kHz)

•

Low-power programmable modulator standby mode

•

Transient output inhibit during PLL lock-up at power-on

•

Logical output port controlled by bus

•

ESD protection, minimum 4 KV

2 Comparing the MC44BS373CA to the MC44BC373/4C

Compared to the MC44BC373/4C devices, the MC44BS373CA has the following improvements:

•

Higher output level (82 versus 74.5 dB

µV)

•

Higher video signal to noise (+3 dB)

MC44BS373CAD Datasheet(PDF) 2 Page - Motorola, Inc

MC44BS373CAD Datasheet(HTML) 2 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Descarga

Enlace URL