CASES

See cases A1 - A3

for pin configurations.

Dot on top of case

indicates pin one.

0.980 max

(24.89)

0.805 max

(20.45)

Materials

Header

Cases A1 and A2

Kovar/Nickel/Gold

Case A3

Kovar/Nickel)

Cover

Kovar/Nickel

Pins

Kovar/Nickel/Gold,

matched glass seal

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device.

Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.

Case A maximum dimensions, Rev B, September 23, 2005

Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,

but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make

changes in products or specifications without notice.

Copyright © 1999-2005 Interpoint Corp. All rights reserved.

CASE A MAXIMUM DIMENSIONS

BOTTOM VIEW