CS43131 datasheet(43/156 Pages) CIRRUS

43 / 156 page

DS1155F1

CS43131

4.6 Clocking Architecture

When the PLL reference clock is supplied to the device through the XTI/MCLK pin, it must comply with the phase-noise

mask shown in Fig. 4-15.

Figure 4-15. MCLK Phase Noise Mask With PLL

Further restrictions are listed in Table 4-3.

Table 4-3. MCLK Source Restrictions

Internal

MCLK

Source

MCLK_SRC_SEL MCLK_INT

Restrictions

Direct MCLK

or XTAL

• Nominal MCLK_INT frequency = 24.576 MHz

• All specified CLKOUT frequencies (generated by PLL or XTAL) are supported

• CLKOUT outputs (/2, /3, /4, /8 divide) optionally

• Nominal MCLK_INT frequency = 22.5792 MHz

• All specified CLKOUT frequencies (generated by PLL or XTAL) are supported

• CLKOUT outputs (/2, /3, /4, /8 divide) optionally

PLL

• Nominal MCLK_INT frequency = 24.576 MHz

• PDN_PLL = 0 and PLL properly configured to generate 24.576 MHz given reference input

frequency on XTI/MCLK pin

• Only MCLK_INT on CLKOUT is supported on CLKOUT pin

• CLKOUT outputs (/2, /3, /4, /8 divide) optionally

• Nominal MCLK_INT frequency = 22.5792MHz

• PDN_PLL = 0 and PLL properly configured to generate 22.5792 MHz given reference input

frequency on XTI/MCLK pin

• Only MCLK_INT on CLKOUT is supported on CLKOUT pin

• CLKOUT outputs (/2, /3, /4, /8 divide) optionally

RCO

• No MCLK_INT selection necessary. DAC playback is not supported. I2C port and HPIN_x

pins are supported.

CS43131 Datasheet(PDF) 43 Page - Cirrus Logic