FDA803D-EHT datasheet(30/78 Pages) STMICROELECTRONICS

No. de pieza	FDA803D-EHT

Descripción Electrónicos	1 x 45 W class D digital input automotive power amplifier with diagnostics, wide voltage operation range for car audio and telematic

PDF	78 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

30 / 78 page

Muting function architecture

FDA803D

30/78

DocID031487 Rev 2

8.2

Analog-Mute

Analog-Mute senses when the mute command signal transits across the muting window,

and attenuates the output signal proportionally to the command signal level inside the

muting window.

Figure 40. Analog-Mute diagram

8.3

Digital-Mute

Digital-Mute acts on the digitally elaborated output signal attenuating it gradually to zero with

digital steps in a pre-defined time frame (tmute). The muting time, (tmute), can be selected by

I2C, (IB6 d7-d6). There are two different actions performed by digital-mute function:

Mute: it starts when any mute command signal, marked as Mixed Mute in Table 7, enters in

the muting window. This event rises the Start-Analog-Mute signal, communicated on

DB6[4]. The muting ends after tmute, selectable through IB6[7-6]. The Start-Analog-Mute

signal is ignored until the muting ramp has ended.

Approximately, the corresponding analog mute attenuation at the beginning of the muting

window is 0.5dB.

UnMute: it starts when all the mute commands, marked with Mixed Mute in Table 7, exit

from the muting window. This event resets the Start-Analog-Mute signal, communicated on

DB6[4]. The unmuting ends after tmute, selectable through IB6[7-6]. The Start-Analog-Mute

signal is ignored until the unmuting ramp has ended.

FDA803D-EHT Datasheet(PDF) 30 Page - STMicroelectronics