8.

“N” is the maximum number of terminal positions for the specified body size. Depopulation is allowed, but

only under the following conditions.

–

Depopulation scheme must be consistent in each quadrant of the package.

–

Non-symmetric variations should be broken out as separate mechanical outline variations, including

depopulation graphics.

9.

A1 is defined as the distance from the seating plane to the lowest point on the package body (standoff).

10. Dimension D2 and E2 refer to exposed pad.

11. Tolerance of Form and Position.

12. Critical dimensions: 12.1 A 12.2 A1 12.3 A3 12.4 D & E 12.5 B & L 12.6 e 12.7 D2 & E2

13. Dimensions “b” / ‘b1’ / ‘b2’ and “L” are measured at terminal plating surface.

STA5635S

VFQFPN32 5x5x1 mm package information

DB4366 - Rev 1

page 5/7