SFECF10M7DF00S0-R0 datasheet(64/77 Pages) MURATA1

64 / 77 page

Notice

Continued on the following page.

Filter is soldered twice within the following temperature

conditions.

1. Standard Reflow Soldering Conditions

2. Wash

(1) Reflow

Electrode is directly soldered with the tip of soldering iron

at +350±5°C for 3.0±0.5 seconds.

(2) Soldering Iron

Do not use strong acidity flux, more than 0.2wt% chlorine

content, in reflow soldering.

(3) Other

2 minutes max. in above solvent at +60°C max.

CFC alternatives (HCFC Series), Isopropyl Alcohol (IPA),

(Cleanthrough-750H, Pine Alpha 100S), Silicon

3. Coating

In case of overcoating the component, conditions such as

material of resin, cure temperature, and so on should be

evaluated well.

(1) Cleaning Solvent

(2) Cleaning Conditions

maintain the temperature of components below the

temperature of solvent.

your application circuit.

solvent.

consult with Murata or a Murata representative prior to

using.

(3) Notice

o Soldering and Mounting

(260°C max.)

Heating

(230°C)

Gradual

Cooling

Pre-heating

(150-180°C)

100

230

260

60-120 sec.

max.

30 sec.

min.

120 sec.

min.

c CERAFILr 455kHz Chip Type SFPKA Series

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.

• This catalog has only typical speciﬁcations. Therefore, please approve our product speciﬁcations or transact the approval sheet for product speciﬁcations before ordering.

SFECF10M7DF00S0-R0 Datasheet(PDF) 64 Page - Murata Manufacturing Co., Ltd

SFECF10M7DF00S0-R0 Datasheet(HTML) 64 Page - Murata Manufacturing Co., Ltd

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77

Datasheet Descarga

Enlace URL