12MHZSLASHSSLASH3.2X2.5 datasheet(20/41 Pages) INFINEON

20 / 41 page

User Manual

20 of 41

Revision 1.6

2019-07-16

EVAL-M3-102T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M3-102T

Figure 10 “Program IMC Controller” pop-up window

After Drive System Parameter file has been programmed into IMC102 controller, and the motor drive system is

powered, the MCEDesigner can be used to start/stop the motor, display motor current traces, change the motor

speed, modify drive parameters and many other functions. Please refer to the MCEDesigner documentation for

more details.

Note:

On-board Debugger portion of EVAL-M3-102T is galvanically isolated from the controller portion

and the attached power board. In order to program the parameters or firmware to the IMC102T-

F064 controller, the 3.3V DC voltage needs to be supplied to the controller portion of the EVAL-M3-

102T. This voltage can either be supplied by the power board (MADK power boards are designed to

supply the 3.3V to the control board through M1 or M3 connector) or by feeding the 3.3V DC voltage

to the control board through some of the available 3.3V access/test points if the power board is not

attached to the EVAL-M3-102T control board.

All latest firmware file for different type of iMOTIONTM control ICs are available for download via Infineon

iMOTIONTMwebsite (http://www.infineon.com/imotion-software).

12MHZ/S/3.2X2.5 Datasheet(PDF) 20 Page - Infineon Technologies AG