FXLS8964AF datasheet(64/98 Pages) NXP

64 / 98 page

NXP Semiconductors

FXLS8964AF

3-Axis Low-g Accelerometer

Field

Description

Z-tilt angle lockout

0: Lockout condition has not been detected.

1: Z-tilt lockout trip angle has been exceeded. Lockout condition has been detected.

Note: The LO bit continues to update with orientation changes even after the NEW_ORIENT flag is

set.

2 to 1

LAPO[1:0]

Landscape/Portrait orientation

00: Portrait up: The device is oriented vertically in the upward direction.

01: Portrait down: The device is oriented vertically in the downward direction.

10: Landscape right: The device is oriented horizontally to the right.

11: Landscape left: The device is oriented horizontally to the left.

Note: The LAPO[1:0] field continues to update with orientation changes even after the NEW_

ORIENT flag is set.

BAFRO

Back or front orientation

0: Front: The device is in the front-facing orientation.

1: Back: The device is in the back-facing orientation.

Note: The BAFRO bit continues to update with orientation changes even after the NEW_ORIENT

flag is set.

Table 83. ORIENT_STATUS register (address 28h) bit description...continued

Notes:

• The BAFRO and LAPO fields are reset to 0 after a POR or soft reset event. These

bits are also automatically cleared after a transition from STANDBY to ACTIVE or

STANDBY to EXT_TRIG modes.

• The current orientation is locked if the absolute value of the acceleration experienced

on any of the three axes is greater than 1.25 g.

15.27 ORIENT_CONFIG register (address 29h)

This register is used to enable the orientation detection function and set the behavior of

the orientation transition debounce counter.

Bit

Name

ORIENT_

DBCNTM

ORIENT_

ENABLE

—

Reset

Access

R/W

Table 84. ORIENT_CONFIG register (address 29h) bit allocation

Field

Description

ORIENT_DBCNTM

Orientation debounce counter mode selection

0: Orientation debounce counter is decremented whenever the current orientation is different than the

previous one.

1: Orientation debounce counter is cleared whenever the current orientation is different than the

previous one.

Table 85. ORIENT_CONFIG register (address 29h) bit description

FXLS8964AF

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 3.4 — 7 December 2021

64 / 98

FXLS8964AF Datasheet(PDF) 64 Page - NXP Semiconductors

FXLS8964AF Datasheet(HTML) 64 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

Datasheet Descarga

Enlace URL