1161 Ringwood Ct, #110, San Jose, CA 95131, U. S. A. Tel.: (408) 748-9100, Fax: (408) 748-9111

www.analogtechnologies.com

Copyrights 2000-2018, Analog Technologies, Inc. All Rights Reserved. Updated on 3/22/2018

www.analogti.com

5

Analog Technologies

ATAS80

Auto Iron

D. Sleep temperature setting

1. press ‘*’ button three times to enter into ‘sleep temperature setting’

2. press ‘#’ to confirm

3. press ‘▲’ ‘▼’ to set sleep temperature

E. Sleep time setting

1. press ‘*’ button four times to enter into ‘sleep time setting’

2. press ‘#’ to confirm

3. press ‘▲’ ‘▼’ to set the required value

4. press ‘#’ to confirm

Note: If you will not be using your soldering unit for a while, remember to put the soldering handle into the handle holder.

When the unit reaches the pre-set sleep time, the tip-temperature will fall automatically to the “sleep temperature” you had

chosen. When you are again ready to work, just pick up the soldering handle from the iron holder. The main power unit

will wake up and enter into your working status mode, once again heating the tip.

TROUBLE SHOOTING

Table 3.

SOLDERING TIP SPECIFICATION CHART

Table 4. Soldering Tips

Product model

Reference diagram

Front view

Product model

Reference diagram

Front view

ATAS80-B

ATAS80-3CC

PHENOMENA

TROUBLE CAUSES

SOLUTIONS

Display ‘E01’

Heating core short circuited

Replace a new heating core

Connector of soldering handle short circuited

Replace a new soldering handle

Display ‘E02’

Heating core loose from handle

Re-Insert heating core into handle

Handle loose from main machine

Re-Insert handle into main machine

Sensor of heating core open circuited

Replace a new heating core

Display ‘E03’

Sensor of heating core short circuited

Replace a new heating core

Connector of handle wire short circuited

Replace a new handle