USB5744 datasheet(10/51 Pages) MICROCHIP

10 / 51 page

USB5744

DS00001855L-page 10

 2022 Microchip Technology Inc. and its subsidiaries

3.2

Pin Descriptions

This section contains descriptions of the various USB5744 pins. This pin descriptions have been broken into functional

groups as follows:

• USB 3.2 Gen 1 Pin Descriptions

• USB 2.0 Pin Descriptions

• USB Port Control Pin Descriptions

• SPI/SMBus Pin Descriptions

• Miscellaneous Pin Descriptions

• Power and Ground Pin Descriptions

The “_N” symbol in the signal name indicates that the active, or asserted, state occurs when the signal is at a low voltage

level. For example, RESET_N indicates that the reset signal is active low. When “_N” is not present after the signal

name, the signal is asserted when at the high voltage level.

The terms assertion and negation are used exclusively. This is done to avoid confusion when working with a mixture of

“active low” and “Active high” signals. The term assert, or assertion, indicates that a signal is active, independent of

whether that level is represented by a high or low voltage. The term negate, or negation, indicates that a signal is inac-

tive.

TABLE 3-2:

PIN RESET STATE LEGEND

Symbol

Description

A/P

Analog/Power Input

Reset Control Input

Hardware disables output driver (high impedance)

PU-50k

Hardware enables internal 50kΩ pull-up

PD-50k

Hardware enables internal 50kΩ pull-down

PD-15k

Hardware enables internal 15kΩ pull-down

PD-1M

Hardware enables internal 1M pull-down

Note:

The buffer type for each signal is indicated in the “Buffer Type” column of the pin description tables. A

description of the buffer types is provided in Section 3.3, "Buffer Types," on page 15.

For additional information on configuration straps and configurable pins, refer to Section 3.4, "Configuration

Straps and Programmable Functions".

USB5744 Datasheet(PDF) 10 Page - Microchip Technology