STM32F469AE datasheet(36/220 Pages) STMICROELECTRONICS

36 / 220 page

Functional overview

STM32F469xx

36/220

DS11189 Rev 7

has a typical frequency of 32 kHz. The RTC can be calibrated using an external 512 Hz

output to compensate for any natural quartz deviation.

Two alarm registers are used to generate an alarm at a specific time and calendar fields can

be independently masked for alarm comparison. To generate a periodic interrupt, a 16-bit

programmable binary auto-reload downcounter with programmable resolution is available

and allows automatic wakeup and periodic alarms from every 120 µs to every 36 hours.

A 20-bit prescaler is used for the time base clock. It is by default configured to generate a

time base of 1 second from a clock at 32.768 kHz.

The 4-Kbyte backup SRAM is an EEPROM-like memory area. It can be used to store data

which need to be retained in VBAT and standby mode. This memory area is disabled by

default to minimize power consumption (see Section 2.22). It can be enabled by software.

The backup registers are 32-bit registers used to store 80 bytes of user application data

when VDD power is not present. Backup registers are not reset by a system, a power reset,

or when the device wakes up from the Standby mode (see Section 2.22).

Additional 32-bit registers contain the programmable alarm subseconds, seconds, minutes,

hours, day, and date.

Like backup SRAM, the RTC and backup registers are supplied through a switch that is

powered either from the VDD supply when present or from the VBAT pin.

2.22

Low-power modes

The devices support three low-power modes to achieve the best compromise between low

power consumption, short startup time and available wakeup sources:



Sleep mode

In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can

wake up the CPU when an interrupt/event occurs.



Stop mode

The Stop mode achieves the lowest power consumption while retaining the contents of

SRAM and registers. All clocks in the 1.2 V domain are stopped, the PLL, the HSI RC

and the HSE crystal oscillators are disabled.

The voltage regulator can be put either in main regulator mode (MR) or in low-power

mode (LPR). Both modes can be configured as follows (see Table 5):

–

Normal mode (default mode when MR or LPR is enabled)

–

Under-drive mode.

The device can be woken up from the Stop mode by any of the EXTI line (the EXTI line

source can be one of the 16 external lines, the PVD output, the RTC alarm / wakeup /

tamper / time stamp events, the USB OTG FS/HS wakeup or the Ethernet wakeup).

STM32F469AE Datasheet(PDF) 36 Page - STMicroelectronics

STM32F469AE Datasheet(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL