–

–

–

–

4

5

Using the Development Boards

All of the module’s connections are made available to the designer via the

wire-wrap header (TS1 / TS2). Jumper shunts have been provided. These

shunts are placed across adjacent pins to control the routing of TX and RX

data. After unpacking the development system, attach an antenna to each

board, install the supplied 9V battery, and turn on the power switches. The

development board is now ready for use.

Troubleshooting

If the boards fail to work out of the box, then try the following:

• Check the battery to make sure it is not dead.

• Make sure that the antenna is connected.

• Make sure that the jumpers are set correctly.

• Ensure that the baud rate selector switches are set the same on both

boards.

• Create and learn a new address.

If all of these appear to be in order, then you can call 800-736-6677 or

e-mail techsupport@linxtechnologies.com.

ES Series Receiver Development Boarad

1. 9V Battery

2. DC Power Jack

3. On-Off Switch

4. Voltage Regulator

5. Host Interface Module

6. Prototype Area

7. Data Squelch Circuit

8. Break-Out Header

9. ES Series Receiver

10. RP-SMA Antenna Connector

11. MS Series Decoder

12. Baud Rate Selector Switches

13. MODE_IND LED

14. LEARN Button

15. Buzzer

16. Relay Output

Figure 4: ES Series Receiver Development Board

1

2

3

4

5

6

7

8

9

15

10

11

12

13

14

16