GLS53 datasheet(19/109 Pages) EMERSON-NETWORKPOWER

19 / 109 page

GLQ352-C, GLQ352-CEF Installation & Operating Instructions

Visit our Web site at www.solahd.com or contact Technical Support at (800) 377- 4384 with any questions

P/N: A272-195 Rev 0 5/6/09 Ref: 03366200121

To comply with the published safety standards, the following must be observed when using

this power supply:

1. Maximum ambient temperature for the power supply must not exceed 50°C.

2. When installing the power supply in the end-use equipment, special attention is

required to ensure safety compliance with the following safety standards: UL60950-1,

EN60950-1, IEC60950-1, and CSA22.2 No. 60950-1-03; including the requirements

for creepage distances, clearances, and distance through insulation between primary

wiring and earth or secondary (SELV) wiring.

3. The power supply’s rated input voltage is automatically selected. Please refer to the

specification sheet for the input voltage range.

4. The maximum output power of the supply must not exceed the rating indicated in the

specification sheet.

5. This unit contains a secondary output exceeding 240 VA. When installing the unit into

the end system, make sure the secondary output and the appropriate wire cannot be

touched.

6. The earth ground wire must be connected only to the point marked with the earth

ground symbol (on the unit).

7. The disconnection from the line must be in the end system.

8. Hazardous voltages exist in the primary circuits. Disconnect the power supply before

servicing.

9. When operating with a dc input voltage range, the unit input must be protected by a dc

rated fuse in the end-use installation system.

10. The internal fuse should only be replaced with a F10AH, 250 V ac, type 216010

manufactured by Littelfuse or type SP001.1014 manufactured by Schurter AG.

11. This equipment is considered Class I according to protection against electric shock.

12. This power supply is

marked following the provisions of the Low Voltage Directive,

2006/95/EC.

13. For technical assistance, contact SolaHD Technical Support at (800) 377- 4384 or send

an e-mail to tech@solahd.com. Please visit our Web site at www.solahd.com for addi-

tional product information and specification sheets.

Output Ratings

Model

Output Voltage (V)

30 CFM Forced Air Cooling (unit not convection rated)

Max. Output Current (A)

Max. Output Power (W)

GLQ352-C (-CEF)

50.0

350 with cover

+12

12.0

-12

6.0

+3.3 to +24

6.0

Mechanical Outline

Top Pot = V4 adj.

Bottom Pot = Main adj.

SK1

SK6

SK4

SK5

SK2

SK3

Bus

Bar

Connector PIN Designation

Input Connector

Designation

SK1

Neutral

Line

Earth GND

Output Connector

Designation

Bus Bar

+5 V

Common

SK2

+12 V

Common

-12 V

Return (float)

+3.3 V to +24 V adj.

SK3

+Sense V4

-Sense V4

+Sense V1

-Sense V1

P OK

C. Share

Dc OK

Inhibit

Common

SK4

+12 V (aux)

Common

SK5

+5 V (aux)

Common

SK6

12 V fan (+)

Fan (-)

GLS53 Datasheet(PDF) 19 Page - Emerson Network Power

GLS53 Datasheet(HTML) 19 Page - Emerson Network Power

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL