ECE1200 datasheet(34/87 Pages) MICROCHIP

No. de pieza	ECE1200

Descripción Electrónicos	eSPI to LPC Bridge

PDF	87 Pages

Scroll/Zoom	100%

Fabricante Electrónico	MICROCHIP [Microchip Technology]

Página de inicio	http://www.microchip.com

Logo

34 / 87 page

ECE1200

DS00003093C Draft-page 34

 2018-2021 Microchip Technology Inc.

6.3.1

The Configuration Port is disabled by default and must be enabled by placing the device into CONFIG MODE. This is

done by writing the value 55h into the INDEX location. Any Reset event to the device, including PLTRST#, will again

disable the interface, requiring it to be re-enabled by this method.

The Configuration Port can also be disabled explicitly by writing the value AAh to the INDEX location. Register accesses

will be disabled until the value 55h is again written to the INDEX location. The Configuration Port still claims I/O transfers

even while disabled, so the Disabled state does not cause these transfers to be propagated to LPC.

FIGURE 6-1:

BLOCK DIAGRAM OF REGISTER SET

Logical Device 0

Registers

Global

Registers

Logical Device 1

Registers

Index = 00h – 2Fh

Index = 30h – FFh

ECE1200 Datasheet(PDF) 34 Page - Microchip Technology