AT25QL641 datasheet(45/77 Pages) DIALOG

No. de pieza	AT25QL641

Descripción Electrónicos	64-Mbit, 1.7V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	77 Pages

Scroll/Zoom	100%

Fabricante Electrónico	DIALOG [Dialog Semiconductor]

Página de inicio	http://www.dialog-semiconductor.com/

Logo

45 / 77 page

AT25QL641

DS-25QL641–130E–10/2018

Figure 7-45. Read Quad Manufacturer/ Device ID Quad I/O instruction (SPI Mode)

7.28

JEDEC ID (9Fh)

For compatibility reasons, the AT25QL641 provides several instructions to electronically determine the identity of the

device. The Read JEDEC ID instruction is compliant with the JEDEC standard for SPI compatible serial Flash memories

that was adopted in 2003. The instruction is entered by driving the CS pin low with following the instruction code “9Fh”.

JEDEC assigned Manufacturer ID byte for Adesto (1Fh) and two Device ID bytes, Memory Type (ID15-ID8) and

Capacity (ID7-ID0) are then shifted out on the falling edge of SCK with most significant bit (MSB) first shown in Figure

7-46 and Figure 7-47. For memory type and capacity values refer to Manufacturer and Device Identification table. The

JEDEC ID can be read continuously. The instruction is terminated by driving CS high.

AT25QL641 Datasheet(PDF) 45 Page - Dialog Semiconductor