PIMXRT516SCVM2A datasheet(63/128 Pages) NXP

63 / 128 page

Electrical characteristics

i.MX RT1170 Crossover Processors Data Sheet for Consumer Products, Rev. 1, 05/2021

NXP Semiconductors

Figure 18. SEMC input timing in SYNC mode

4.5.2

FlexSPI parameters

Measurements are with a load 15 pf and input slew rate of 1 V/ns.

4.5.2.1

FlexSPI input/read timing

There are three sources for the internal sample clock for FlexSPI read data:

•

Dummy read strobe generated by FlexSPI controller and looped back internally

(FlexSPIn_MCR0[RXCLKSRC] = 0x0)

•

Dummy read strobe generated by FlexSPI controller and looped back through the

DQS pad (FlexSPIn_MCR0[RXCLKSRC] = 0x1)

•

Read strobe provided by memory device and input from DQS pad

(FlexSPIn_MCR0[RXCLKSRC] = 0x3)

The following sections describe input signal timing for each of these three internal sample clock sources.

4.5.2.1.1

SDR mode with FlexSPIn_MCR0[RXCLKSRC] = 0x0, 0x1

Table 51. FlexSPI input timing in SDR mode where FlexSPIn_MCR0[RXCLKSRC] = 0X0

Symbol

Parameter

Min

Max

Unit

Frequency of operation

—

MHz

TIS

Setup time for incoming data

8.67

—

TIH

Hold time for incoming data

—

Table 52. FlexSPI input timing in SDR mode where FlexSPIn_MCR0[RXCLKSRC] = 0X1

Symbol

Parameter

Min

Max

Unit

Frequency of operation

—

133

MHz

TIS

Setup time for incoming data

—

TIH

Hold time for incoming data

—

PIMXRT516SCVM2A Datasheet(PDF) 63 Page - NXP Semiconductors

PIMXRT516SCVM2A Datasheet(HTML) 63 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL