MODEL: R5-TS1A

R5-TS1A SPECIFICATIONS

ES-7571 Rev.8 Page 2/4

http://www.m-system.co.jp/

OUTPUT SPECIFICATIONS

Operational range: Approx. 0 – 24 mA DC

INSTALLATION

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R5-BS)

Weight: 100 g (3.53 oz)

PERFORMANCE

Conversion accuracy

Input: ±0.4°C (±0.6°C for C thermocouple)

±0.8°F (±1.1°F for C thermocouple)

Output: ±0.1 % of the retransmitted range + input

conversion accuracy (May exceed ± 0.1 % depending upon

the input temperature range.)

Conversion data: Temperature data scaled and converted

into 0 – 100 % data and supplied to the internal network bus

Data allocation: 1

Cold junction compensation error: ±0.5°C or ±0.9°F

(at 20°C ±10°C or 68°F ±18°F)

Temp. coefficient

Input: ±0.015 %/°C (±0.008 %/°F)

Output: ±0.02 %/°C (±0.01 %/°F)

Response time: ≤ 0.4 sec. (0 – 90 %)

Burnout response time: ≤ 2 sec.

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 1500 V AC @ 1 minute (input to output

to internal bus or internal power)

2000 V AC @ 1 minute (power input to FG; isolated on the

power supply module)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581

FUNCTIONS

• Zero/Span Adjustment Modes

Monitor Mode

Re-transmits the input signal as output in proportion.

Output 0 % Adjustment Mode

Adjusts the 0 % output signal using the front UP/DOWN

buttons, in monitoring the output value with a multimeter.

SW1 through SW3 switch the internal increments by 1, 5

and 10.

Output 100 % Adjustment Mode

Adjusts the 100 % output signal using the front UP/DOWN

buttons, in monitoring the output value with a multimeter.

SW4 through SW6 switch the internal increments by 1, 5

and 10.

Simulated Output Mode

Outputs the simulated signals of 0 %, 50 % and 100 %.

• How to Operate

1) Start up in Monitor Mode (SW position = 0) and wait for 2

or 3 seconds.

2) Switch to another mode and go through the adjustments.

3) Reset the switch to the position ‘0’ so that the new

setting is stored in the internal memory.