Technical Data Sheet

3M™ Polyurethane Protective Tape 8673 & 8673DL

B. Physical Properties

Property

Test Method

Units

Typical Value

Tensile Strength @ Break

ASTM D882

lb/in (N/100 mm)

70 (1228)

Elongation % @ Break

ASTM D882

%

500

Peel Adhesion @ 70°F (21°C) to:

Bare Aluminum

Acrylic Enamel Paint

ABS Plastic

ASTM D-1000 oz/in (N/100 mm)

69 (76)

48 (52)

55 (60)

Max. Service Temperature

°F (°C)

200°F (93°C)

General Information

•

3M 8673 and 8673DL Tapes may be painted per 3M™ Technical Bulletin “Polyurethane Protective Tape, Paint

Instructions” (70-0702-6358-0).

•

3M™ Adhesion Promoter 86A* may be used with 3M 8673 Tape and 3M 8673DL Tapes to increase adhesion for

difficult substrates or longer term or permanent applications.

•

If edge sealing is required, for protection against moisture or fluid exposure, 3M™ Scotch-Weld™ Epoxy

Adhesive DP190 is frequently used.

*Note: Consult local air quality rules which may regulate product use.

Safety and Regulatory

This product is considered to be an article that does not release or otherwise result in exposure to a hazardous

chemical under normal use conditions.

Shipping and Storage

No special/hazardous labeling or packaging required and no regulations for air, ground or water shipment for this

product. Keep film in a clean area, away from excessive moisture and out of direct sunlight. Store rolls in the shipping

carton. Return partially used rolls to the shipping carton. Shelf Life: Two (2) years from the date of manufacture or as

certified by 3M.

Precautionary Information

Refer to Product Label and Safety Data Sheet for health and safety information before using this product. For additional health and

safety information, call 1-800-364-3577 or (651) 737-6501, and visit www.3m.com/3M/en_US/company-us/SDS-search/

For Additional information

In the U.S., call toll free 1-800-235-2376, or fax 1-800-435-3082 or 651-737-2171. For U.S. Military, call 1-866-556-5714.