Product Specification

LB170E01-SL01

Liquid Crystal Display

Note :

1. The specified current and power consumption are under the V

whereas Typical Power Pattern[Mosaic] shown in the [ Figure 3 ] is displayed.

2. The current is specified at the maximum current pattern.

3. Maximum Condition of Inrush current :

The duration of rush current is about 5ms and rising time of power Input is 500us ± 20%.(min.).

Max luminance and White pattern with the normal frame frequency operated(60Hz).

5. The operation of LED Driver below minimum dimming ratio may cause flickering or reliability issue.

6. This Spec. is not effective at 100% dimming ratio as an exception because it has DC level equivalent

to 0Hz. In spite of acceptable range as defined, the PWM Frequency should be fixed and stable for

more consistent brightness control at any specific level desired.

7. The life is determined as the time at which luminance of the LED is 50% compared to that of initial

value at the typical LED current on condition of continuous operating at 25 ± 2°C

Ver. 1.0

Dec. 16. 2013

7 / 31

Typical power Pattern

Maximum power Pattern

FIG.3 Mosaic pattern & White Pattern for power consumption measurement