NXP Semiconductors

Product Specification

Security Transponder (HITAG2)

PCF7936AS

Please be aware that important notices concerning this document and the product(s)

described herein, have been included in the section 'Legal information'.

© NXP B.V. All rights reserved.

For more information, please visit: http://www.nxp.com

For sales office addresses, email to: sales.addresses@www.nxp.com

14 LEGAL INFORMATION

14.1 Data sheet status

Document status

Product status

Definition

Objective [short] data sheet

Development

This document contains data from the objective specification or product development

Preliminary [short] data sheet

Qualification

This document contains data from the preliminary specification

Product [short] data sheet

Production

This document contains the product specification

14.2 Definitions

Draft

The document is a draft version only. The content is still under internal review and subject to formal approval, which may result in modifications or additions. NXP

Semiconductors does not give any representations or warranties as to the accuracy or completeness of information included herein and shall have no liability for the

consequences of use of such information.

Short data sheet

A short data sheet is an extract from a full data sheet with the same product type number(s) and title. A short data sheet is intended for quick reference only and

should not be relied upon to contain detailed and full information. For detailed and full information see the relevant full data sheet, which is available on request via

the local NXP Semiconductors sales office. In case of any inconsistency or conflict with the short data sheet, the full data sheet shall prevail.

14.3 Disclaimers

General

Information in this document is believed to be accurate and reliable. However, NXP Semiconductors does not give any representations or warranties, expressed or

implied, as to the accuracy or completeness of such information and shall have no liability for the consequences of use of such information.

Right to make changes

NXP Semiconductors reserves the right to make changes to information published in this document, including without limitation specifications and product

descriptions, at any time and without notice. This document supersedes and replaces all information supplied prior to the publication hereof.

Suitability for use

NXP Semiconductors products are not designed, authorized or warranted to be suitable for use in medical, military, aircraft, space or life support equipment, nor in

applications where failure or malfunction of a NXP Semiconductors product can reasonably be expected to result in personal injury, death or severe property or

environmental damage. NXP Semiconductors accepts no liability for inclusion and/or use of NXP Semiconductors products in such equipment or applications and

therefore such inclusion and/or use is at the customer’s own risk.

Applications

Applications that are described herein for any of these products are for illustrative purposes only. NXP Semiconductors makes no representation or warranty that

such applications will be suitable for the specified use without further testing or modification.

Limiting values

Stress above one or more limiting values (as defined in the Absolute Maximum Ratings System of IEC 60134) may cause permanent damage to the device. Limiting

values are stress ratings only and operation of the device at these or any other conditions above those given in the Characteristics sections of this document is not

implied. Exposure to limiting values for extended periods may affect device reliability.

Terms and conditions of sale

those pertaining to warranty, intellectual property rights infringement and limitation of liability, unless explicitly otherwise agreed to in writing by NXP

Semiconductors. In case of any inconsistency or conflict between information in this document and such terms and conditions, the latter will prevail.

No offer to sell or license

Nothing in this document may be interpreted or construed as an offer to sell products that is open for acceptance or the grant, conveyance or implication of any

license under any copyrights, patents or other industrial or intellectual property rights.