TPS16632 datasheet(20/43 Pages) TI1

20 / 43 page

VIN

FLTb

IIN

TPS1663

SLVSET9D – SEPTEMBER 2018 – REVISED AUGUST 2019

www.ti.com

Product Folder Links: TPS1663

Submit Documentation Feedback

Feature Description (continued)

(1)

VIN = 24 V

RILIM = 3 kΩ

Figure 23. Start-Up With Short on Output

9.3.5 Output Power Limiting, PLIM (TPS16632 Only)

In TPS16630, with a fixed overcurrent limit threshold the maximum output power limit increases linearly with

supply input. Electrical Industrial process control equipment such as PLC CPU needs to comply with standards

like IEC61010-1 and UL1310 for fire safety which require limited energy and power circuits. Limiting the output

power becomes a challenge in such high power applications where the operating supply voltage range is wide.

The TPS16632 integrate adjustable output power limiting functionality that simplifies the system design requiring

compliance in accordance to this standard.

Connect a resistor from PLIM to GND as shown in Figure 24 to set the output power limiting value. If output

power limiting is not required then connect PLIM to GND directly. This disables the PLIM functionality.

During an over power load event the TPS16632 limits the output power at the programmed value set by PLIM

resistor. This indirectly results in the device operation in current limiting mode with steady state output voltage

and current set by the load characteristics and PLIM = VOUT × IOUT. Figure 8 shows the output power limit and

current limit characteristics of TPS16632 with 100 W power limit setting. The maximum duration for the device in

power limiting mode is 162 msec (typical), tCL_PLIM(dly). After this time, the device operates either in auto-retry or

latch off mode based on MODE pin configuration in Table 1.

P(PLIM) = 1 x R(PLIM)

(5)

Here P(PLIM) is output power limit in watts, R(PLIM) is the power limit setting resistor in kΩ.

During the output power limiting operation, FLT asserts after a delay of tCL_PLIM_FLT(dly). The FLT signal

remains asserted until the over power load condition is removed and the device resumes normal operation.

Figure 25 illustrate output power limiting performance of TPS16632 with 100 W setting for class-2 power supply

designs .

TPS16632 Datasheet(PDF) 20 Page - Texas Instruments