SM-K-SH-109DM-2C-R datasheet(4/4 Pages) SANYOU

4 / 4 page

SM-K

4/4

Operate

Release

Operate

Release

Operate

Release

Announcements

：

1 The magnetic latching relay is to be supplied with contacts close(Operate) or contacts open(Release),

2 In order to make sure the contacts are completely closed or opened,

be the nominal operate

/release voltage,

specification but less than

1 minute.

status may got changed due to unexpected shock or vibration during delivering or mounting.

Do not apply power to Operate and Release coils at the same time

statusaccording to your requirement

but the contact

You can reset the contact

energized voltage to Operate or Release coil should

impulse width should be

5 times more than specified operate/release time in the

P.C. Board Layout of single coil (bottom view)

Wiring diagram of

single coil (bottom view)

positive polarity(as below)

Operate

Release

Operate

Release

Operate

Release

reverse polarity(as below)

Disclaimer:

This datasheet is the customers' reference. All the specification are subject to change without notice.

We could not evaluate all the performance and all the parameters for every possible application.Thus the user should

in a right position to choose the suitable product for their own application.For sealed relays after installation and cleaning,

please open the vent hole on the case before use.If there is any query,please contact Sanyou for the technica service.

SM-K-SH-109DM-2C-R Datasheet(PDF) 4 Page - Sanyou Corporation Limited