PKGS-00GXP1-R datasheet(4/15 Pages) MURATA

4 / 15 page

Reference only

P.4 /15

MURATA MANUFACTURING CO., LTD

7. Physical Characteristics

Test Item

Condition of Test

Performance Requirements

7-1

Mechanical

Shock

The transducer shall be measured after being

applied

three

impacts

plus

and

minus

directions of three mutually perpendicular planes.

The shock is specified as 29400m/s

2(3000G)

half sine pulse of 0.3 ms duration.

No visible damage and the

measured values shall meet

Table 2

7-2

Vibration

The transducer shall be measured after being

applied vibration of amplitude of 1.5 mm with 10

to 55 Hz band of vibration frequency to each of 3

perpendicular directions for 2 hours.

( 5 minutes

 24 cycles )

7-3

Bend Strength

PCB

The transducer is soldered onto the center of

PCB (1.6 mm thickness) which is laid on the 2

small supporters spaced 90 mm.

PCB is deflected to 1 mm below from horizontal

level by the pressing force with 20

 10. R10

stick. The force is supplied for 1 second, 5 times

repeatably.

No visible damage and the

measured values shall meet

Table 3

7-4

Resistance

Reflow

Soldering

The transducer shall be mounted on PCB, then

measured after being applied following reflow

conditions.

Pre-heating :

60 to 150 sec. at 150 to 180

C

Heating :

Within 60 sec. at 200

C (or more)

Within 30 sec. at 250

C (or more)

Peak Temperature:

Within 10 sec. at 260

C

Shock sensor should be tested 2 times of this

test flow.

PCB size

: 115

 80  0.8 mm

After being placed at ambient conditions for 8

hours, the transducer shall be measured.

No visible damage and the

measured values shall meet

Table 2

7-5

Solderability

End terminals are immersed in rosin for

5 seconds then immersed in soldering bath of

+230

5C for 30.5 seconds.

75% min. end terminals shall

be wet with solder.

7-6

Washability

See Table 1

No visible damage and the

measured values shall meet

Table 2

Part

Stick

PCB

R10

 5 Supporter

1 Off-Center

Unit: mm

Load

Deflection

PKGS-00GXP1-R Datasheet(PDF) 4 Page - Murata Manufacturing Co., Ltd.

PKGS-00GXP1-R Datasheet(HTML) 4 Page - Murata Manufacturing Co., Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Datasheet Descarga

Enlace URL