MP2016DD datasheet(4/4 Pages) MPS

4 / 4 page

EV2016DD-00A HIGH VOLTAGE, LOW POWER LINEAR REGULATOR EV BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV2016DD-00A Rev. 1.0

www.MonolithicPower.com

10/10/2011

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

QUICK START GUIDE

The output voltage of this board is set to 5V. The EN pin is connected to VIN with a 100kΩ resistor for

automatic startup. You can connect EN to GND to disable the MP2016.

1. Attach the positive and the negative ends of the load to the VOUT and GND pins respectively.

2. Attach an input voltage (7V ≤ VIN ≤ 42V) and input ground to the VIN and GND pins respectively.

3. The output voltage (VOUT) can be changed by setting a resistor divider (R1 and R2). A 24.9kΩ

(±1%) resistor should be used for the low-side resistor R2 of the voltage divider. The high side

resistor R1 can be determined by the equation:

OUT

R1 R2

1.23V

⎛⎞

=×

−

⎜⎟

⎝⎠

Where the 1.23V is the feedback threshold voltage (VFB).

MP2016DD Datasheet(PDF) 4 Page - Monolithic Power Systems