ST10F166BQ1 datasheet(39/62 Pages) STMICROELECTRONICS

39 / 62 page

ST10F166

39/62

Notes:

1) This specification does not apply to the analog input (Port 5.x) which is currently converted.

3) The maximum current may be drawn while the respective signal line remains inactive.

4) The minimum current must be drawn in order to drive the respective signal line active.

5) This specification is only valid during Reset, or during Hold-mode.

6) Not 100% tested, guaranteed by design characterization.

7) The supply current is a function of the operating frequency. This dependency is illustrated in the figure

below.

These parameters are tested at VCCmax and 20 MHz CPU clock with all outputs disconnected and all inputs

at VIL or VIH.

8) This value is guaranteed also after ESD qualification trials at 25 degrees

Pin capacitance 6)

(digital inputs/outputs)

–

f= 1 MHz

A =25 °C

Power supply current

–

80 +

5* fCPU

RSTIN = V

IL2

fCPU in [MHz]

Idle mode supply current

–

35 +

1.5 * fCPU

RSTIN = V

IH1

fCPU in [MHz]

Power-down mode supply current

TBD

µA–

PP read current

PPR

–200

µAV

PP >VCC

PP write current

PPW

–50

1/TCL = 40 MHz

32-bit program-

ming

PP =12 V

PP during write/read

11.4

12.6

Parameter

Symbol

Limit Values

Unit

Test Condition

min.

max.

DC Characteristics (Cont’d)

ST10F166BQ1 Datasheet(PDF) 39 Page - STMicroelectronics

ST10F166BQ1 Datasheet(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datasheet Descarga

Enlace URL