LPS33HW datasheet(23/50 Pages) STMICROELECTRONICS

No. de pieza	LPS33HW

Descripción Electrónicos	MEMS pressure sensor: 260-1260 hPa absolute digital output barometer with water-resistant package

PDF	50 Pages

Scroll/Zoom	100%

Fabricante Electrónico	STMICROELECTRONICS [STMicroelectronics]

Página de inicio	http://www.st.com

Logo

23 / 50 page

DocID030522 Rev 1

23/50

LPS33HW

Application hints

Figure 13. LPS33HW electrical connections (top view)

The device power supply must be provided through the VDD line; a power supply

decoupling capacitor C1 (100 nF) must be placed as near as possible to the supply pads of

the device. Depending on the application, an additional capacitor of 4.7 μF could be placed

on the VDD line.

The functionality of the device and the measured data outputs are selectable and accessible

through the I²C/SPI interface. When using the I2C, CS must be tied to Vdd_IO.

All the voltage and ground supplies must be present at the same time to have proper

behavior of the IC (refer to Figure 13). It is possible to remove VDD while maintaining

Vdd_IO without blocking the communication bus, in this condition the measurement chain is

powered off.

5.1

Soldering information

The CCLGA package is compliant with the ECOPACK® standard and it is qualified for

soldering heat resistance according to JEDEC J-STD-020.

LPS33HW Datasheet(PDF) 23 Page - STMicroelectronics