Features

• 8-bit HCS08 Central Processor Unit (CPU)

– Up to 40 MHz CPU at 5.5 V to 2.7 V across temperature range of –40 °C to 85 °C and –40 °C to 105 °C

– HCS08 instruction set with added BGND instruction

– Support for up to 32 interrupt/reset sources

• On-Chip Memory

– 32 KB or 18 KB dual array flash; read/program/erase over full operating voltage and temperature

– 1984 byte random access memory (RAM)

– Security circuitry to prevent unauthorized access to RAM and flash contents

• Power-Saving Modes

– Two low-power stop modes (stop2 and stop3)

– Reduced-power wait mode

– Peripheral clock gating register can disable clocks to unused modules, thereby reducing currents

– Low power on-chip crystal oscillator (XOSC) that can be used in low-power modes to provide accurate clock source to real time counter and LCD controller

– 100 μs typical wakeup time from stop3 mode

• Clock Source Options

– Oscillator (XOSC) — Loop-control Pierce oscillator; crystal or ceramic resonator range of 31.25 kHz to 38.4 kHz or 1 MHz to 16 MHz

– Internal Clock Source (ICS) — Internal clock source module containing a frequency-locked-loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2% resolution and 2% deviation over temperature and voltage; supports bus frequencies from 1 MHz to 20 MHz.

• System Protection

– COP reset with option to run from dedicated 1 kHz internal clock or bus clock

– Low-voltage warning with interrupt

– Low-voltage detection with reset

– Illegal opcode detection with reset

– Illegal address detection with reset

– Flash and RAM protection

• Development Support

– Single-wire background debug interface

– Breakpoint capability to allow single breakpoint setting during in-circuit debugging (plus two more breakpoints

in on-chip debug module)