|
Features:
•Four adjustable high efficiency buck regulators: 1.75 A, 1.5 A, 1.25 A, 1.0 A
•Selectable modes: PWM, PFM, APS
•5.0 V, 600 mA boost regulator with PFM or auto mode
•Six adjustable general purpose linear regulators
•Input voltage range: 2.8 V to 4.5 V or 3.7 V to 5.5 V
•OTP (One Time Programmable) memory for device configuration
•Programmable start-up sequence and timing
•Selectable output voltage, frequency, soft start
•I2C control
•Coin cell charger and always ON RTC supply
•DDR reference voltage
•-40 °C to +125 °C operating junction temperature
Applications
•Tablets•eReaders•Wearables•POS terminals•Industrial control•Medical monitoring•Home automation•Home security/energy managementEP
2General description
The PF3000 is the power management integrated circuit (PMIC) designed primarily for use with NXP’s i.MX 7 series of multi-media application processors. It is also capable of providing full power solution to i.MX 6SL/SX/UL processors.
2.1Features
This section summarizes the PF3000 features.
•Input voltage range to PMIC: 2.8 V to 4.5 V, or 3.7 V to 5.5 V (3)
•Buck regulators
•Configurable three to four channels
•SW1A/B, 2.75 A (single); 0.7 V to 1.425 V, 1.8 V, 3.3 V
•SW1A, 1.0 A (independent); 0.7 V to 1.425 V, 1.8 V, 3.3 V
•SW1B 1.75 A (independent); 0.7 V to 1.475 V
•SW2, 1.25 A; 1.50 V to 1.85 V or 2.50 V to 3.30 V
•SW3, 1.5 A; 0.90 V to 1.65 V
•Dynamic voltage scaling
•Modes: PWM, PFM, APS
•Programmable output voltage
•Programmable current limit
•Programmable soft start sequence
•Programmable PWM switching frequency
•Boost regulator
•SWBST, 5.0 to 5.15 V, 0.6 A, OTG support
•Modes: PFM and Auto
•OCP fault interrupt
•LDOs
•VCC_SD, 1.8 V to 1.85 V or 2.85 V to 3.30 V, 100 mA based on SD_VSEL
•V33, 2.85 V to 3.30 V, 350 mA
•VLDO1, 1.8 V to 3.3 V, 100 mA
•VLDO2, 0.80 V to 1.55 V, 250 mA
•VLDO3, 1.8 V to 3.3 V, 100 mA
•VLDO4, 1.8 V to 3.3 V, 350 mA
•Always ON RTC Regulator/Switch VSNVS 3.0 V, 1.0 mA
•DDR memory reference voltage, VREFDDR, 0.5 V to 0.9 V, 10 mA
•OTP (One time programmable) memory for device configuration, user-programmable start-up sequence and timing
•Battery backed memory including coin cell charger
•I2C interface
•User programmable standby, sleep/LPSR, and Off modes
|