MoBL-USB™ FX2LP18 USB Microcontroller

Cypress Semiconductor Corporation’s MoBL-USB™ FX2LP18 (CY7C68053) is a low voltage (1.8 V) version of the EZ-USB® FX2LP (CY7C68013A), which is a highly integrated, low power USB 2.0 microcontroller. By integrating the USB 2.0 transceiver, serial interface engine (SIE), enhanced 8051 microcontroller, and a programmable peripheral interface in a single chip, Cypress has created a very cost effective solution that provides superior time-to-market advantages with low power to enable bus powered applications.

Features
■ USB 2.0 9 V USB-IF high speed and full speed compliant (TID# 40000188)
■ Single-chip integrated USB 2.0 transceiver, smart SIE, and enhanced 8051 microprocessor
■ Ideal for mobile applications (cell phone, smart phones, PDAs, MP3 players)
   ❐ Ultra low power
   ❐ Suspend current: 20 µA (typical)
■ Software: 8051 Code runs from:
   ❐ Internal RAM, which is loaded from EEPROM
■ 16 kBytes of on-chip code/data RAM
■ Four programmable BULK/INTERRUPT/ISOCHRONOUS endpoints
   ❐ Buffering options: double, triple, and quad
■ Additional Programmable (BULK/INTERRUPT) 64-Byte Endpoint
■ 8 or 16-Bit External Data Interface
■ Smart Media Standard ECC Generation
■ GPIF (General Programmable Interface)
   ❐ Allows direct connection to most parallel interface
   ❐ Programmable waveform descriptors and configuration registers to define waveforms
   ❐ Supports multiple Ready and Control outputs
■ Integrated, Industry Standard Enhanced 8051
   ❐ 48 MHz, 24 MHz, or 12 MHz CPU operation
   ❐ Four clocks per instruction cycle
   ❐ Three counter/timers
   ❐ Expanded interrupt system
   ❐ Two data pointers
■ 1.8 V Core Operation
■ 1.8 V to 3.3 V I/O Operation
■ Vectored USB Interrupts and GPIF/FIFO Interrupts
■ Separate Data Buffers for Setup and Data Portions of a CONTROL Transfer
■ Integrated I2C Controller, runs at 100 or 400 kHz
■ Four Integrated FIFOs
   ❐ Integrated glue logic and FIFOs lower system cost
   ❐ Automatic conversion to and from 16-bit buses
   ❐ Master or slave operation
   ❐ Uses external clock or asynchronous strobes
   ❐ Easy interface to ASIC and DSP ICs
■ Available in Industrial Temperature Grade
■ Available in one Pb-free Package with up to 24 GPIOs
   ❐ 56-pin VFBGA (24 GPIOs)