■ GENERAL DESCRIPTION
The XC9116 series is a fixed frequency, constant current step-up DC/DC converter ideal for driving LEDs used in backlighting applications such as cellular phones, PDAs and digital cameras. Output voltage of up to 17.5V can be derived, therefore, four white LEDs in series can be driven. Since an LED current can be set by an external resistor when LEDs are in-series connection, all white LEDs can be turned on equably. A network of two parallel legs with three in each LED can be also driven. Luminance of the LEDs is controlled by changing the duty cycle of a PWM signal applied to the CE pin. Efficiency is high with the low feedback reference voltage ensuring the RLED losses are minimal. In addition, an internal MOSFET with an RDSON of 2.0 Ω is used. A low profile and small board area solution can be achieved using a chip coil and an ultra small ceramic output capacitor (CL) of 0.22μ F as a result of the high 1.0MHz switching frequency.
The B type of XC9116 has an additional fault detection circuit. If the LEDs are disconnected or damaged, excess or run away output voltage is prevented by stopping the drive of the internal MOSFET.

■ FEATURES
    Input Voltage Range : 2.5V ~ 6.0V
    Output Voltage Range : Up to 17.5V externally set-up
                                         : Reference voltage 0.2V +5%
    Oscillation Frequency : 1.0MHz, ±20%
    ON Resistance : 2.0Ω
    Efficiency : 86% (XC9116B Type)
                     : 84% (XC9116D Type)
                        (VIN=3.6V, ILED=20mA when
                        driving 3 white LEDs in series)
    Control : PWM control
    Standby current : ISTB=1.0μ A (MAX.)
    Load Capacitor : 0.22μ F, ceramic
    Lx Limit Current : 325mA
    Lx Overvoltage Limit : XC9116B series
    No Lx Overvoltage Limit : XC9116D series
    Package : SOT-25 (SOT-23-5), USP-6B

■ APPLICATIONS
● For White LED drivers
● Mobile phones, PHS
● PDAs
● Digital still cameras