Description
The STEVAL-IOD04KT1 is a reference design kit that exploits the features of the L6364W IO-Link dual-channel device transceiver. The kit consists of the STEVAL-IOD004V1 main board (not available for sale), the STLINK-V3MINI programmer and debugger tool, a 14-pin flat cable, and an M8 to M12 standard industrial connector adapter. The kit acts as a modern smart industrial sensor to be connected to a master IO-Link hub (or a suitable PLC interface). The power supply for the MCU, sensors, and other logic devices derives from the DC-DC converter controller embedded in the L6364W. The on-board STM32G071EB microcontroller runs an IO-Link demo stack v.1.1, which controls the IO-Link communication, and the software code that manages the L6364W transceiver and the MEMS industrial sensors. Product summary Industrial smart sensor kit based on L6364W dual IO-Link device transceiver STEVAL-IOD04KT1 Software pack for STEVAL-IOD04KT1 with IO-Link stack v1.1, IODD, and control software for industrial sensors STSW-IOD04K Dual channel IOLink device transceiver in CSP

Features
■ Kit content: – STEVAL-IOD004V1 (45.8 x 8.3 mm) main board with shape easy to be integrated in industrial sensors housing (not available for separate sale) – STLINK-V3MINI programmer and debugger tool – M8-M12 industrial connector adapter including a 20 cm cable – 14-pin flat cable
■ Main board features: – Industrial sensor node based on STM32G071EB (mainstream Arm® Cortex®-M0+ RISC core MCU operating at up to 64 MHz frequency), L6364W (dual channel transceiver IC for SIO and IO-Link sensor applications), IIS2MDC (high accuracy, ultra-low-power, 3-axis digital output magnetometer) and ISM330DHCX (iNEMO inertial module with machine learning core, and finite state machine with digital output for industrial applications) – Runs an IO-Link v.1.1 demo-stack and MEMS control software, included in the companion package STSW-IOD04K together with the IODD file – Operating voltage range 7 to 32 V – Four-pole M8 industrial standard connector – L6364W embedded DC-DC converter provides 3.3 V supply for all on- board ICs – General-purpose LEDs for transmission, programming/debugging, warning, and status – Jumpers for CQ and DIO selection in independent or joint mode – Switch for transmission mode selection (transparent, single, or multioctet) – Reset button – 10-pin connector for sensor expansion options – SWD connector for debugging and programming capability – Protections against surge pulse (up to ± 3APK with 500 Ω coupling) and reverse polarity – EMC and EMI tested according to standard requirements – RoHS compliant