Features
■ Heavy weight release liner for diecutting − EtO & Gamma Sterilization Compatible
■ Easy to Apply
■ − Clear Film Carrier
■ Adheres to a wide range of substrates Composition: Tape caliper, no liner 6.3 mil (0.16 mm) Double Coated Polyethylene Tape Carrier 3 mil (0.08 mm) Transparent Polyethylene Film Adhesive Acrylate designed for medical/surgical use Release Liner 80 lb. Bleached Kraft paper, silicone release both sides (4.5 mil/0.11mm) Typical Properties+: 180° Peel Adhesion to Stainless Steel, Face [Open] side 28 oz/inch width (800 gm/25mm) Liner Release 9 gm/inch width (9 gm/25 mm) + Properties listed based on very limited data and subject to change. Methods available upon request. Roll Description: Tape supplied on 3 inch (76 mm) diameter cores. Length 550 yards (503 m) ± 2% Maximum Width 48 inch (122 cm) ± 1/32 in (1.0 mm) Number of Splices: Splices on the tape are intended for continuous processing. Roll Width Maximum Number of Splices per Roll < 8 inch (20 cm) 2 per 100 yd (91 m) 3 per 200 yd (183 m) 6 per 550 yd (503 m) Information on the splice frequency in roll widths greater than 8 inch (20 cm) is available upon request. Packaging and Recommended Storage Product as supplied in original packaging will maintain stated properties for a period of three (3) years from date stamped on shipping container when stored at temperatures of 50-80°F (10-27°C) and a relative humidity of 40-60 percent. Please see reverse side for important product, safety and warranty information.