TMS320DM355CZCEA13 datasheet(133/163 Pages) TI1

133 / 163 page

DIN<9:0>

DACDigitalInput

CBG

0.1 F

VREF

VideoDACandBuffer

RBIAS

2550 Ω

IBIAS

Rfb = 1000 Ω

IOUT

VFB

TVOUT

Rout =1070 Ω

TVmonitor

TVOUT[V]

VideoBufferOutputVoltage

MSB

LSB

OL(VIDBUF)

OH(VIDBUF)

TMS320DM355

www.ti.com

SPRS463G – SEPTEMBER 2007 – REVISED JUNE 2010

Place capacitors and resistors as close as possible to the DM355.

You must use the circuit shown in this diagram. Also you must configure the VDAC_CONFIG register in the System

Control module as follows: TRESB4R4 = 0x3, TRESB4R2 = 0x8, TRESB4R1 = 0x8, TRIMBITS = 0x34, PWD_BGZ =

1 (power up VREF), SPEED = 1 (faster), TVINT = don't care, PWD_VBUFZ = 1 (power up video buffer), VREFSET =

don't care, ACCUP_EN = 0 (no A/C coupling), DINV = 1 (invert). See TMS320DM35x Digital Media System-on-Chip

(DMSoC) ARM Subsystem Reference Guide (literature number SPRUFB3) and the TMS320DM35x Digital Media

System-on-Chip Video Processing Back End (VPBE) Reference Guide (literature number SPRUF72) for more

information on the VDAC_CONFIG register and Video Buffer.

For proper TVOUT voltage, you must connect the pin TVOUT directly to the TV. No A/C coupling capacitor or

termination resistor is necessary on your DM355 board. Also, it is assumed that the TV has no internal A/C coupling

capacitor but does have an internal termination resistor, as shown in this diagram. TVOUT voltage will range from

VOL(VIDBUF) to VOH(VIDBUF). See Section 4.3 for the voltage specifications.

Figure 5-32. DAC With Buffer Circuit

DM355 Peripheral Information and Electrical Specifications

133

Submit Documentation Feedback

Product Folder Link(s): TMS320DM355

TMS320DM355CZCEA13 Datasheet(PDF) 133 Page - Texas Instruments