STM32F217VG datasheet(163/175 Pages) STMICROELECTRONICS

163 / 175 page

DocID17050 Rev 9

163/175

STM32F21xxx

Revision history

174

25-Nov-2010

Added WLCSP66 (64+2) package. Added note 1 related to LQFP176

on cover page.

Update I/Os in Section : Features.

Updated Table 5: Multi-AHB matrix.

Added case of BOR inactivation using IRROFF on WLCSP devices in

Section 3.15: Power supply supervisor.

Reworked Section 3.16: Voltage regulator to clarify regulator off

modes. Added Section 3.19: VBAT operation.

Modified VDD_3 pin in Table 7: STM32F21x pin and ball definitions, and

added note related to the FSMC_NL pin.

Renamed BYPASS-REG REGOFF, and add IRROFF pin.

Changed VSS_SA to VSS, and VDD_SA pin reserved for future use.

Updated maximum HSE crystal frequency to 26 MHz.

USART4/5 renamed UART4/5. USART4 pins renamed UART4 in

Table 7: STM32F21x pin and ball definitions. Updated LIN and IrDA

features for UART4/5 in Table 5: USART feature comparison.

Section 6.2: Absolute maximum ratings: Updated VIN minimum and

maximum values and note for non-five-volt tolerant pins in Table 10:

Voltage characteristics. Updated IINJ(PIN) maximum values and related

notes in Table 11: Current characteristics.

Updated VDDA minimum value in Table 13: General operating

conditions.

Added Note 2 and updated Maximum CPU frequency in Table 14:

Limitations depending on the operating power supply range; and

added Figure 19: Number of wait states versus fCPU and VDD range.

Renamed Brownout Low, medium and High reset thresholds,

Renamed VBORL/VBORM/VBORH, VBOR1/VBOR2/VBOR3 in Table 18:

Embedded reset and power control block characteristics.

Changed fLSI typical value in Table 32: LSI oscillator characteristics.

Added Figure 33: ACCLSI versus temperature.

Changed fOSC_IN maximum value in Table 29: HSE 4-26 MHz

oscillator characteristics.

Changed fPLL_IN maximum value in Table 33: Main PLL

characteristics, and updated jitter parameters in Table 34: PLLI2S

(audio PLL) characteristics.

Section 6.3.16: I/O port characteristics: updated VIH and VIL in

Table 45: I/O static characteristics.

Added Note 1 below Table 46: Output voltage characteristics.

Updated RPD and RPU parameter description in Table 56: USB OTG

FS DC electrical characteristics.

Updated VREF+ minimum value in Table 65: ADC characteristics.

Updated Table 70: Embedded internal reference voltage.

Removed Ethernet and USB2 for 64-pin devices in Table 93: Main

applications versus package for STM32F2xxx microcontrollers.

Added A.2: USB OTG full speed (FS) interface solutions, removed

“OTG FS connection with external PHY” figure, updated Figure 85,

Figure 86, and Figure 87 to add STULPI01B.

Table 93. Document revision history (continued)

Date

Revision

Changes

STM32F217VG Datasheet(PDF) 163 Page - STMicroelectronics

STM32F217VG Datasheet(HTML) 163 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Descarga

Enlace URL