For price, delivery, and to place orders, please contact Hittite Microwave Corporation:

20 Alpha Road, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373

Order On-line at www.hittite.com

8

8 - 8

Evaluation PCB

The circuit board used in the final application

should use RF circuit design techniques. Signal

lines should have 50 ohm impedance while the

package ground leads and package bottom should

be connected directly to the ground plane similar to

that shown. A sufficient number of via holes should

be used to connect the top and bottom ground

planes. The evaluation board should be mounted

to an appropriate heat sink. The evaluation circuit

board shown is available from Hittite upon request.

Item

Description

J1, J2

PCB Mount K Connector

J3 - J5

DC Pin

C1, C2

100 pF Capacitor, 0402 Pkg.

C3, C4

10 nF Capacitor, 0603 Pkg.

C5, C6

4.7 μF Capacitor, Tantalum

U1

HMC263LP4E

123963 Evaluation PCB

[1] Reference this number when ordering complete evaluation PCB

[2] Circuit Board Material: Rogers 4350 or Arlon 25 FR

HMC263LP4E

v01.0709

GaAs MMIC LOW NOISE

AMPLIFIER, 24 - 36 GHz