7733 datasheet(274/940 Pages) RENESAS

No. de pieza	7733

Descripción Electrónicos	16-BIT SINGLE-CHIP MICROCOMPUTER

PDF	940 Pages

Scroll/Zoom	100%

Fabricante Electrónico	RENESAS [Renesas Technology Corp]

Página de inicio	http://www.renesas.com

Logo

274 / 940 page

A-D CONVERTER

7733 Group User’s Manual

9–9

(1) Interrupt priority level selection bits (bits 2 to 0)

These bits select an A-D conversion interrupt’s priority level. When using A-D conversion interrupts,

select one priority level from levels 1 to 7. If an A-D conversion interrupt request occurs, its priority

level is compared with the processor interrupt priority level (IPL), and the requested interrupt is

enabled only when its priority level is higher than the IPL. (Note that this is applied to the case where

the interrupt disable flag (I) = “0.”) When disabling A-D conversion interrupts, set these bits to “0002”

(Level 0).

(2) Interrupt request bit (bit 3)

This bit is set to “1” when an A-D conversion interrupt request occurs. This bit is automatically cleared

to “0” when the A-D conversion interrupt request is accepted.

Note that this bit can be set to “1” or cleared to “0” by software.

9.2 Block description

7733 Datasheet(PDF) 274 Page - Renesas Technology Corp