SH7708 datasheet(422/633 Pages) RENESAS

422 / 633 page

404

Bits 3 to 0: These bits have the same function as in the ordinary SCI. See section 13, Serial

Communication Interface, for more information. The setting conditions for bit 2, the transmit end

bit (TEND), are changed as follows.

Bit 2: TEND

Description

Transmission is in progress.

TEND is cleared to 0 when software reads TDRE after it has been set to 1, then

writes 0 in TDRE, or when data is written in SCTDR.

End of transmission.

(Initial value)

TEND is set to 1 when:

• the chip is reset or enters standby mode,

• the TE bit in SCSCR is 0 and the FER/ERS bit is also 0,

• the C/A bit in SCSMR is 0, and TDRE = 1 and FER/ERS = 0 (normal

transmission) 2.5 etu after a one-byte serial character is transmitted, or

• the C/A bit in SCSMR is 1, and TDRE = 1 and FER/ERS = 0 (normal

transmission) 1.0 etu after a one-byte serial character is transmitted.

Note:

etu is an abbreviation of elementary time unit, which is the period for the transfer of 1 bit.

14.3

Operation

14.3.1

Overview

The primary functions of the smart card interface are described below.

1. Each frame consists of 8 data bits and 1 parity bit.

2. During transmission, the card leaves a guard time of at least 2 etu (elementary time units: the

period for 1 bit to transfer) from the end of the parity bit to the start of the next frame.

2. During reception, the card outputs an error signal low level for 1 etu after 10.5 etu has elapsed

from the start bit if a parity error was detected.

4. During transmission, it automatically transmits the same data after allowing at least 2 etu from

the time the error signal is sampled.

5. The specification complies with ISO/ICE7816-3, but the only type of data transmission

protocol supported is protocol type T = 0 : asynchronous double-character transmission

protocol.

SH7708 Datasheet(PDF) 422 Page - Renesas Technology Corp