M16CSLASH62 datasheet(477/615 Pages) RENESAS

477 / 615 page

Address Match Interrupt

Mitsubishi microcomputers

M16C / 62A Group

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

2-160

2.12.2 Operation of Address Match Interrupt

The following is an operation of address match interrupt. Figure 2.12.4 shows the set-up procedure of

address match interrupt, and Figure 2.12.5 shows the overview of the address match interrupt handling

routine.

Operation (1) The address match interrupt handling routine sets an address to be used to cause the ad-

dress match interrupt register to generate an interrupt.

(2) Setting the address match enable flag to “1” enables an interrupt to occur.

(3) An address match interrupt occurs immediately before the instruction in the address indicated

by the address match interrupt register as a program is executed.

Figure 2.12.4. Set-up procedure of address match interrupt

Can be set to “0000016” to “FFFFF16”

(b23)

(b16)

Address match interrupt register 0 [Address 001216 to 001016]

RMAD0

Address match interrupt register 1 [Address 001616 to 001416]

RMAD1

Setting address match interrupt enable register

Address match interrupt enable register [Address 000916]

AIER

Address match interrupt 0 enable bit

1: Interrupt enabled

Setting address match interrupt register

(b15)

(b8)

(b20)

(b19)

Address match interrupt 1 enable bit

1: Interrupt enabled

M16C/62 Datasheet(PDF) 477 Page - Renesas Technology Corp