HD6432351 datasheet(595/1025 Pages) RENESAS

595 / 1025 page

Section 13 Serial Communication Interface (SCI)

Rev. 3.00 Sep 15, 2006 page 561 of 988

REJ09B0330-0300

Bit 4—Framing Error (FER): Indicates that a framing error occurred during reception in

asynchronous mode, causing abnormal termination.

Bit 4

FER

Description

[Clearing condition]

(Initial value)*

When 0 is written to FER after reading FER = 1

[Setting condition]

When the SCI checks whether the stop bit at the end of the receive data when

reception ends, and the stop bit is 0*

Notes: 1. The FER flag is not affected and retains its previous state when the RE bit in SCR is

cleared to 0.

2. In 2-stop-bit mode, only the first stop bit is checked for a value of 0; the second stop bit

is not checked. If a framing error occurs, the receive data is transferred to RDR but the

RDRF flag is not set. Also, subsequent serial reception cannot be continued while the

FER flag is set to 1. In clocked synchronous mode, serial transmission cannot be

continued, either.

Bit 3—Parity Error (PER): Indicates that a parity error occurred during reception using parity

addition in asynchronous mode, causing abnormal termination.

Bit 3

PER

Description

[Clearing condition]

(Initial value)*

When 0 is written to PER after reading PER = 1

[Setting condition]

When, in reception, the number of 1 bits in the receive data plus the parity bit does not

match the parity setting (even or odd) specified by the O/

E bit in SMR*2

Notes: 1. The PER flag is not affected and retains its previous state when the RE bit in SCR is

cleared to 0.

2. If a parity error occurs, the receive data is transferred to RDR but the RDRF flag is not

set. Also, subsequent serial reception cannot be continued while the PER flag is set to

1. In clocked synchronous mode, serial transmission cannot be continued, either.

HD6432351 Datasheet(PDF) 595 Page - Renesas Technology Corp