L9678P datasheet(149/203 Pages) STMICROELECTRONICS

149 / 203 page

DocID029274 Rev 3

149/203

L9678P, L9678P-S

Safing logic

202

By way of the assignment of the ADD_VAL, SUB_VAL, ARMP_TH and ARMN_TH settings,

the safing engine can be configured to assert arming for either a simple accumulation of

COUNTs in a non-consecutive manner, or it could be set to require some number of

consecutive samples.

10.5

Safing engine output logic (ARMxINT)

SPI messages are monitored and mapped to specific safing records. Each safing record is

configured with its own threshold, dwell time and the appropriate ARMxINT internal signal to

activate if safing criteria are met.

Any enabled safing record can be programmed to an arming signal. All safing records

arming status is logically "OR'd" to its programmed arming signal. For example, if safing

records 1, 2, 4 are programmed to ARMINT1 and the records are enabled, any of the

records can set the ARMINT1 signal. Configuration of safing record mapping to ARMxINT

signals is specified in the SAF_CONTROL_x register (refer to Safing control registers

(SAF_CONTROL_x) on page 106).

While in Diag state, L9678P allows diagnostics of the squib driver HS and LS FETs, ARM

pin, VSF output and firing timers. The ARM and VSF output tests are mutually exclusive.

For safety purposes, the safing logic circuitry is physically separated from the circuitry that

contains the deployment logic.

L9678P Datasheet(PDF) 149 Page - STMicroelectronics